Timpdon Electronics SCS2, Быстрый старт

Страница: 5 / 8

Timpdon Electronics Tel 0161 - 980 7804 Issue 2 – October 2010
Web www.timpdon.co.uk
EMail sales@timpdon.co.uk
When satisfied, press and hold both switches S1 and S2 together until the
LED illuminates continuously, after about two seconds. Then release both
switches.
2 You are now in Step 2 – Program Set Position .
The LED will flash with double short flashes.
Adjust the required set position using either S2 to increase the servo
position or S1 to decrease it. The actual rotation direction is servo
dependent.
When satisfied, press and hold both switches S1 and S2 together until the
LED illuminates continuously, after about two seconds. Then release both
switches.
3
You are now in Step 3 – Program Rotation Speed .
The LED will flash with single long flashes.
In programming step 3, the servo will rotate continuously between the two
end positions which have already been programmed, at the current
rotation speed.
There are sixteen steps of rotation speed, varying from about 0.25 s to 20
s for 90 degree rotation. Press and release S2 to increase the speed by
one step, or press and release S1 to decrease it by one step.
Please read the Cautionary Notes below before attempting to use very
high rotation speeds.
After the last step, the rotation speed will revert to the other end of the
speed scale.
When satisfied, press and hold both switches S1 and S2 together until the
LED illuminates continuously, after about two seconds. Then release both
switches.
4 You are now in Step 4 – Program Reset Bounce Level .
The LED will flash with single long followed by single short flashes.
In programming step 4, the servo will rotate continuously between the
programmed Reset position and the position represented by current Reset
Bounce level, at the programmed rotation speed.