Timing Solutions TSC 4033A, Руководство по эксплуатации и обслуживанию

Страница: 11 / 27

4033A Operations and Maintenance Manual 11
Switch at the Power Entry Module or the power supply cord set is not accessible when the
unit is mounted inside an enclosed rack.
After power-on, the unit runs a self-test in the following sequence:
•
All LEDs will be turned on GREEN
•
Each output LED will sequentially be turned on RED and then GREEN.
•
The input and output LEDs will be in the appropriate state relative to their respective
signal status.
2.4.3.2 Input Signal
Connect the input signal cable to the INPUT BNC connector on the back of the unit.
2.4.3.3 Output Signals
Connect up to fifteen cables to the OUTPUT BNC connectors on the rear panel of the unit to
supply users with a copy of the input signal.
2.4.3.4 LAN - Ethernet Network Port
Connect a network LAN cable (not supplied with the unit) to the LAN port on the back of the
unit.
2.5 Assigning a Static IP Address
The 4033A contains a Lantronix® Xport™ Ethernet to RS-232 converter, which provides the
4033A’s Ethernet connection.
The 4033A ships from the factory with a default IP address of 0.0.0.0, which enables DHCP. If
the network has a DHCP server, it will automatically assign the unit an IP address, gateway
address, and subnet mask when the unit starts up.
To monitor multiple 4033As remotely through their Ethernet connections without DHCP re-
assigning IP addresses, you must assign each unit a static IP address. You identify which unit is
the source of an alarm by its IP address. Each unit has its own unique hardware address, labeled
MAC address, on a label on the rear panel. Follow the instructions in this section to manually
assign a unit’s static IP address.
Note
For more detailed information, see the Xport™ User Manual. Section 3.3 discusses several
different ways that you can assign IP addresses. Chapter 4 explains how to configure a static IP
address. You can download the
Xport™ User Manual from the Lantronix® Web site as an
Adobe® Acrobat® PDF file. Go to:
http://www.lantronix.com/products/eds/xport/XPort_UM_900-270.pdf
If you want to configure a static IP address of many different 4033As, you can install the
Lantronix® DeviceInstaller software. This software is available only by downloading from the
Lantronix® Web site. Go to:
http://www.lantronix.com/support/utils/dst/index.html . Alternatively