13
Fischer Information
Fischer part no Description
S102A056-130+
K210/K220 input plug
S102A056-230+
K210/K220 control plug
102.248 + A
4.7mm collet (4.3
– 4.7 cable)
E32 102.1/2.1+A 2.1mm collet (1.5
– 2.1 cable)
E32 102.1/2.6+A 2.6mm collet (2.1
– 2.6 cable)
E32 102.1/3.1+A 3.1mm collet (2.6
– 3.1 cable)
E32 102.1/3.6+A 3.6mm collet (3.1
– 3.6 cable)
E32 102.1/4.1+A 4.1mm collet (3.6
– 4.1 cable)
E32 102.1/4.3+A 4.3mm collet (4.1
– 4.3 cable)
Distributor list available on:
K210/K220 Power Connector
1. Lemo connector is supplied complete, take apart as shown in above picture.
2. Put the nut and spacer on the power cable and push the positive wire up into the
connecter.
3. Solder the positive wire ont o the pin, ensure the wire does not touch anywhere else
inside the connector.
4. The ground wire should be clamped between the spacer and the connector, screwing
the nut in pac e will secure the ground cable against the inside of the connector.
5. Place the divider inside the connector, this ensures
the positive wire doesn’t touch
any other part of the connector.
6. Screw the end piece in plac e over the divider.
Lemo Uk Ltd part no
FLA.00.250.CTA C29
End
Divider
Connector
Spacer
Nut