SWEEP FREQ PLOT
Under this menu, T100+ can plot any of the
following measured data over the desired
frequency range:
•SWR
•IMPEDANCE (Z)
•RESISTANCE (R)
•REACTANCE (X)
•RETURN LOSS (S11)
•PHASE ANGLE
Use the MODE key to switch cyclically
between any of the following parameters to
change their value.
•
FREQUENCY
- use the ARROW keys to
increment or decrement the frequency by the
value of STEP SIZE. The cursor on the plot
will move accordingly. The frequency can
also be entered directly using the numeric
keys.
•
Y SCALE
- use the ARROW keys to select
the maximum value on the Y axis. Possible
values are 3, 10, 30, 100, 300, and 1000.
•
ALIGNMENT
- use the ARROW keys to select
if the directly entered frequency should be
aligned to the CURRENT position of the
cursor, BEGIN (leftmost on the plot), CENTER
(of the plot), or END (rightmost of the
plot). Ranges outside the valid frequencies
will be shaded.
•
STEP SIZE
- use the ARROW keys to select
the desired frequency step size. Possible
values are 25KHz, 100KHz, 500KHz,and 1MHz.
timestechnology.com.hk
9
