TimeIPS
http://support.timeips.com 316.264.1600
Page 9
If no network connection is detected, TimeIPS will display
:
If no network connection is detected, check the network cable on the back of the
TimeIPS station. Unplug and reconnect the network cable at both ends and/or try a
different network cable.
For master station:
If you're trying to connect a master station, write the IP address shown on the LCD
display (Fig. C) in the space provided below.
http://_____._____._____._____
Although the message on the LCD display (Fig C.) has not changed, you will proceed
with instructions on the next page to begin configuring the TimeIPS master station.
For client station:
Unplug the power cord from the station, wait 1 minute and then plug it back in. This
will allow the client station to search for a master station. If a master station is located,
the TimeIPS LCD will display:
If the client station is still unsuccessful in locating the master station, please contact
technical support for further assistance.
Note: After a client has connected to a Master at least once, you will see the following
display if the Master subsequently becomes unavailable.
Fig. D
2008-01-01 12:00 PM
T ype or scan your ID
Fig. C
Welcome t o T imeIPS
Net work
disconnect ed
Please check cables
T ry 169.254.34.161
Step 3) Network Connection Verification (cont.)
Th e actu al IP address sh own on you r
LCD display will be differen t from th is
exam ple.
Note:
The above message (Fig. C) will remain on the LCD display after reconnecting the network cable.
Th is m essage in dicates th at th e
station 's con figu ration is
com plete.
Note:
If you see the message (Fig. D) above and you only have one TimeIPS station, this is your
master station and it has already been configured. It is now ready to accept clock-in/clock-out events.
Fig. E
IP: 169.254.34.161
MAST ER NOT FOUND
Press Ent er or swipe
badge t o t ry again
If you see this message (Fig. E) it indicates that the client is no longer
able to reach the master station. Pressing Enter or swiping a badge
will restart networking and the connection to the master. If you
continue to get this message, check your network, master and/or
restart the client system.
