Initial Configuration of the IPS125T
The clock will continue the start-up process for about another 30-60 seconds. When
the start-up process is complete you should see a screen similar to this:
Your new clock must connect to a master station in order to allow your employees
to clock in and out. Using your keypad (or a USB keyboard if you do not have a
keypad) select Search for Master and press Enter. The screen on your IPS125T
should flash “Starting System” for a few seconds. You should then see a screen that
looks similar to this:
Setting a Remote Master IP Address
If your IPS125T returned to the “Clock Not Set Up” screen, it was unable to
connect to your master station. If your master station is outside of your local
network, you will need to specify the IP address of that master. Select “Configure
Network” and press Enter. Scroll down to “Set Master IP” and press Enter. You
should see a screen similar to this:
Page 8
http://support.timeips.com 316.264.1600
TimeIPS
After the employee identification device(s) and network cable are attached, power-
on the clock by plugging in the power adapter. In 10-15 seconds you should see
“Starting System” on the LCD. (If not, unplug for 2-3 seconds and try again.)
Step 2) Network Connection Verification
Clock Not Set Up
>Search For Master
Configure Network
Clean Shutdown
Step 1) Setting Up the IPS125T
Oct 03, 12:00:00PM
+: In : Out
/: Check Status
or enter your ID
Oct 03, 12:00:00PM
NETWORK SETUP
Enter Master
This screen indicates that the
clock's configuration is complete.
Enter the IP address of your
TimeIPS master system here.
Upper case (AM/PM) indicates the clock is
communicating with your server. Lower case (am/pm)
indicates the clock is operating in offline mode.
Starting in version 5.2.15, you may use the arrow keys
on the keypad to navigate to Select Language and
change the interface of the clock to Spanish if you
prefer.
