4
Installation
Decide on a position for the
alarm unit and magnet/sensor ensuring that the
twin flex is sufficiently long to connect the sensor
to the alarm unit and that there is good access to
the slide switch and battery compartment on the
alarm unit.
Fix the magnet to the edge of the chosen door or
window using two of the smaller screws or one of
the double-sided adhesive pads provided. Fix the
sensor to the door or window frame directly
opposite the magnet with any arrow on the
magnet pointing towards the arrow on the sensor.
The gap between the magnet and the sensor must
be 6mm or less.
The alarm unit may now be fixed to the wall by
drilling two holes 43mm vertically apart and using
the two larger screws and wall plugs supplied.
Remove the terminal cover from the sensor by
pressing down at the centre and sliding out. Route
the twin flex from the alarm unit to the sensor and
remove any excess allowing for termination. Strip
around 12mm of insulation from each wire and
insert the stripped wires under the sensor terminal
screw heads and tighten.
TG232W_Instructions.qxd 2/5/06 4:17 pm Page
