Timberwolf TW PTO/S426, Инструкция по эксплуатации

Страница: 13 / 49

TW PTO S426
10 / 45
OPERATING INSTRUCTIONS
24.06.2019
AUTO CONTROLS
The no stress unit controls the feed rate of the material going into the shredding chamber. If the engine speed is below
the predetermined level, the no stress unit will not allow the feed roller to work in the forward “infeed” direction, until
the drum speed rises above the predetermined level. At this point, the feed roller will start turning without warning.
The reverse function will work at any engine speed.
STOPPING THE SHREDDER
Push the RED safety bar (see control panel diagram on page 9). •
Keeping PTO engaged set tractor speed to idle. •
When idle speed steady stop tractor engine. •
When engine stationary disengage PTO clutch. •
DO NOT disengage the PTO clutch while engine is running as the shredder cutting disc may continue to free wheel •
for a long time.
PUSH THE RED SAFETY BAR
TURN OFF TRACTOR IGNITION KEY OR OPERATE TRACTOR STOP LEVER.
The emergency stop will prevent any more material being fed into the shredder. The drum will still be turning. The
tractor must be disengaged or powered down to stop the drum.
EMERGENCY STOPPING
STARTING THE SHREDDER
Connect the tractor power cable. •
Start tractor. •
Turn on side lights to allow 12 volts to the shredder - the socket and side lights must work. •
Gently engage PTO clutch. •
Increase tractor revs until tractor PTO speed = 1000 rpm. DO NOT RUN ON ANY OTHER PTO SPEED SETTING. •
Check that shredder is running smoothly. •
Press the green control button. The roller will commence turning. •
Stand to one side of the feed funnel. •
Proceed to feed material into the feed funnel. •
Check that shredder is running smoothly. •
Release the catches on the feed tray and lower. •
Press the green control button. The roller will commence turning. •
Stand to one side of the feed funnel. •
Proceed to feed material into the feed funnel. •
At the end of operations allow sufficient time for all shredded material to be ejected from the discharge before •
switching off.
STARTING TO SHRED
DO NOT USE OR ATTEMPT TO START THE SHREDDER
WITHOUT THE PROTECTIVE GUARDING AND DISCHARGE
UNIT SECURELY IN PLACE. FAILURE TO DO SO MAY RESULT IN
PERSONAL INJURY OR LOSS OF LIFE.
WARNING
DO NOT USE OR ATTEMPT TO START THE SHREDDER
WITHOUT THE PROTECTIVE GUARDING AND DISCHARGE
UNIT SECURELY IN PLACE. FAILURE TO DO SO MAY RESULT IN
PERSONAL INJURY OR LOSS OF LIFE.
WARNING