Timberk WHEL-3
OC, Инструкция по эксплуатации

Страница: 7 / 24

ENGLISH
When pressure in the water mains exceeds 0.6 MPa, OBLIGATORY installa-
tion of a pressure reducing valve is required.
It is recommended to use a shutoff safety valve at the cold water inlet.
Connect the water heater to the water pipeline (threaded pipe outlet with
obligatory installation of a valve to shut off water feed to the water heater)
using a separate flexible hose (! not included to the package).
CERTAINLY install all sealing gaskets included to the package and coarse
filter, which is fitted at the cold water inlet.
At that, it is necessary to observe the OBLIGATORY REQUIREMENT:
The water feed shutoff valve shall be installed upstream of the water heater
inlet.(Proper installation of the water heater is shown in Fig.2)
PROHIBITED:
Installation of a shutoff valve at the hot water outlet from the water
heater.
(Fig.2a) This will result in failure of the water heater and may inflict
harm to the user.
Water heater installation
- Remove the enclosure of the water heater unscrewing three mounting
screws.
- Select the electric cable entry place. If necessary, cut the thin wall on the
enclosure in the proper place using a knife.
- Selection the water heater installation place.
- Install the appliance on the wall horizontally with its connections strictly
downward securing it with screws from the set of installation fixtures
included by the manufacturer to the package.
NOTE:
Installation of the water heater in the operation place and arrange-
ment of a power supply line shall be performed by a specialized
organization, representatives of the manufacturer's service
department, or specialists having permits for installation of electric
equipment with observations of safety requirements.
If the installation and operation instruction manual of the water heater
is violated, the appliance is not subject to warranty service and the
manufacturer does not bears the responsibility.
Connection to water mains
The water heater shall be connected to the water mains with water pres-
sure from 0.03 to 0.6 MPa. The water heater can be fed with water from a
tank, where water level shall be at least by 4 m above the water heater level.
ATTENTION!
When the water heater is operated in particularly difficult (includ-
ing obsolete) water pipeline systems with a large quantity of sus-
pended particles and impurities in flowing water, application of
purification filters at the inlet of the water heater is OBLIGATORY.
Use this recommendation; otherwise, non-fulfilment of this item
may affect service life of the product and warranty service condi-
tions (up to refusal of warranty liabilities by the product manufac-
turer and manufacturer's service departments).
Fig. 1
Kitchen Shower Bathroom
www.timberk.com i nstant water heater electric