Timberk TMS 08.CH, Инструкция по эксплуатации

Страница: 12 / 36

9. OPERATING AN INFRARED HEATER BY THE REMOTE CONTROL UNIT ( g. 2, g.3)
1. Programming
Prior to the rst use of an infrared heater by the remote control unit or replacement of
batteries in the remote controller, it should be programmed in accordance with the heater
model, to do this:
- connect the infrared heater to a power supply unit,
- press ON/OFF button, mode 1 symbol and
« » symbol will start blinking on the remote
controller's display, and POWER indicator will ash on the control unit.
- press
« » or « » button within 10 seconds to select mode 1 (for TCH A2) or mode 2
(for TCH A1N) according to the heater model.
- to nish the selection, press MODE and hold it for 5 seconds, the MODE number symbol
stop blinking and the symbol LOCK will display on the LCD. Only nished this process, the
setting of HEAT and TIMER could be carried out.
NOTE :
If the mode is selected incorrectly, the control unit will make a triple sound signal. In this
case the mode must be reselected according to the heater model, to do this press MODE
button and hold it for 5 seconds, then repeat the above actions.
12 w ww.timberk. com remote control block