Timberk THU UL 04, Инструкция по эксплуатации

Страница: 7 / 20

9 . Cleaning and maintenance of the unit
Prior to cleaning make sure that the plug is disconnected from an outlet.
Otherwise it may result in an electric shock.
Before cleaning, wait until water in the base device is completely cooled
down in order not to burn hands.
Clean the unit once or twice a week.
9.1 To wipe the external surface of the unit use a damp and soft cloth.
To prevent an electric shock do not scratch and do not damage unit s
elements upon cleaning.
When cleaning the unit, do not use solvents, benzine, dimethylbenzene, hard
brush, talc powder and other substances other than water.
9.2 Wipe water remains inside the base device under the tank by a damp
and soft cloth.
To remove water remains on small parts you can use the brush, and then wipe
them again with a soft cloth.
9.3 If there is dirt on the membrane, clean it by means of a brush.
9.4 Use a brush to remove water remains on the surface of the nozzle
and then wipe it again by a soft cloth.
9.5 Clean the water tank and the atomizer by pure water.
Clean the cap
carefully, without applying much effort, otherwise it may result in water
leakage through the cap.
Once water remains are removed from the surface of the atomizer, wipe it
by a soft cloth.
Clean the external surface of the unit by a damp and soft cloth.
10. Troubleshooting
In case of emergencies resort to troubleshooting methods, given in table 5.
Poor atomizing
(insufficient
performance)
Remedy Defect Possible cause
The unit is operating in
a light mode (low
atomizing frequency)
No defect. If necessary to switch to the intensive
mode, press « STEAM » button in
the manual setting mode and switch the unit
to the intensive operation mode.
Atomizer is clogged Clean the atomizer
Tank water temperature
is too low
Set the maximum performance. Humidifier s
performance will be increased in 10 minutes
No atomizing The plug is poorly
inserted into an outlet
Connect the plug into an outlet carefully
Red light on the water
indicator has illuminated
and went out (water
tank is completely empty)
Add water to the tank
A white residue appeared
on objects around the
humidifier (salts,
separating from water)
Lime deposits are formed
on the membrane
Clean the humidifiers membrane by a special brush
Water demineralization
cartridge is worn down
(ion exchange resin).
Inused water contains
a large amount a caleium
or magnesium.
Replace the cartridge.
No warm atomizing Use of warm steam is
not selected
Press « HEART » button in the manual setting
mode and switch the unit to a warm steam
humidification mode
Operation has just started No defect. It will take about 10-20 minutes
for warm steam to be atomized (time, required
for water heating by the heater after
it s switched on)
Difference between the
level of current humidity
and readings of a
humidity recorder
is too big
Dirt accumulation
inside an air vent
Clean the air vent. Even in one room humidity
can be different depending on the location
The unit is operated in
places, where it is affected
by the environment,
for example, by a window
Install the unit in places, where it cannot be
affected by the environment
Steam has an
unpleasant odor
Signal 1 is given
Signal 2 is given
Not fresh water in use
Tank full sound signal
Fan operation
sound signal
There are remains of
not fresh water or litter
in the water groove
Clean the unit in accordance with the cleaning
and maintenance manual and fill it with fresh
water
No defect in the unit, keep on its operation
Table 5 .
ENGLISH
Fig . 10
Fig . 11
1 1. Utilization
If you are unable to solve issues by means of mentioned methods,
contact a service center.Life of the humidifier is 2 years.
Upon expiration of the humidifier it must be disposed in accordance with
regulations, rules and by means, currently in force at a disposal station.
The base of the device
Membrane
Use a filtred water.