Timberk TFH T20MDR, Инструкция по эксплуатации

Страница: 17 / 20

IM2022
17
4. To turn off the heater, set the power mode switch to «0» position, and unplug the appliance
from the mains.
NOTE:
During the first use of heater odor and smoke may appear. It means that at the time of
production a drop of oil got on the heating element. Oil drop will quickly evaporate - the smell
and the smoke will not appear again.
8. MAINTANANCE
Before starting a cleaning, make sure that:

Power mode switch is set to «0» («OFF») position and the unit is unplugged.
Recommendations for regular cleaning:

Disconnect the unit from the mains by unplugging the power cord from the electrical outlet,
allow the device to cool, then wipe it with a soft, slightly damp cloth.

It is not recommended to use detergents, including abrasive compounds for cleaning

Do not damage the surface of the device with sharp objects.
9. TROUBLESHOOTING
If it is impossible to fix these malfunctions with these methods, contact the authorized service
center.
Malfunction Possible cause Solution
The device is connected
to the network but
doesn’t
work
No power
Check whether the power
supply is disconnected from
the device and, if necessary,
connect device to power
supply
Defective operation mode
switch
Contact an authorized service
center
Defective motor
Low heating temperature is
set on thermostat
Set the temperature higher on
thermostat by rotating the
handle clockwise
Faulty contact connection in
wiring scheme of electrical
circuit Contact an authorized service
center or restore reliable
contact connection
Temperature limiter parted
electrical circuit and shut off
the heating elements
Ensure that the air inlet or
outlet grille is not blocked by
foreign objects and wait for
turning on of the temperature
limiter, after the body of
the device cools down
Malfunction in circuit breaker Change the circuit breaker
Power cord is broken
Contact an
authorized service center to
fix it
The room temperature is
higher than the temperature
set by the thermostat Turn the thermostat handle
clockwise until the heaters
turn on
The device is connected to
electric
network, heating
mode is set, the electric motor
Low heating temperature is
set on thermostat
Set the temperature higher on
thermostat by rotating the
handle clockwise