Timberk TAP FL250 SF BL, Инструкция по эксплуатации

Страница: 12 / 16

IM2020
12
7. CONTROL PANEL
Fig. 2
*Image is for reference only and may differ from actual control panel.
- on/off button
NIGHT LIGHT
– night mode of operation
SLEEP/1/2/3
– speed indicators
SPEED
– purification speed selection button
TIMER
– timer settings button
UV
– UV lamp button
HEPA/PRE
– filter changing reminder indicator. HEPA – HEPA filter, PRE – pre-filter.
8.
OPERATION OF THE DEVICE
Turning On/Off
To turn on the device, press the button on the control panel. Operation indicator will be glowing at the
lower part of the device. To turn off the device, press the button again, the indicator will go out.
Ion generator
– ionization function starts automatically after turning on the device. The function is turning off
after the device turns off.
Timer function
The device can be programmed to turn off after a certain amount of time. To program the timer, press
“TIMER” button. Time can be selected in the following sequence – 2-4-8 hours.
Fan speed adjustment
The device can operate in the following speed modes
– SLEEP – minimal speed for silent operation during
sleep, “1” (low speed), “2” (medium speed), “3” (high speed). To select the speed press the “SPEED” button
several times and select the speed mode. Selected speed mode will be shown by indicators.
«HEPA/PRE» indicators
When one of the indicators is turned on it is necessary to change the specific filter. After the filter has been
changed, to reset the indicator press both TIMER and UV button for 3 seconds. The indicator will flash three
times and then will turn off.