Timberk SWH
RE3
100
V, Инструкция по эксплуатации

Страница: 8 / 28

8
2. G1/2 diameter pipes are used to connect the water heater to the water
pipeline.
3. To prevent a leakage when connecting pipes, use rubber sealing gaskets
on the threaded pipe ends.
4. Screw a relief valve to the inlet nozzle, marked blue and embossed arrow
of the water flow direction, so that the water flow direction coincides with
direction of the arrow on the valve's case.
NOTE:
Do not mount additional accessories, such as a shut-off valve, between
the relief valve and the inlet nozzle.
IMPORTANT!
If water in the installation location contains a large amount of
calcium, manganese or iron salts, then IT IS NECESSARY to mount a
respective filter in the delivery system to reduce the amount of scale
generated in the tank and on the heating element.
Connection to electric main
IMPORTANT!
Prior to connecting the storage water heater, make sure that the
water heater is properly grounded. Proper grounding is
important to minimize electric shocks and risk of fire. The power
cord is equipped with a plug with a grounding pin. The appliance
must be used with a properly grounded power outlet. If the
outlet, you are intending to use, is not properly grounded or
grounded by a time-delay fuse or a circuit breaker, contact a
qualified electrician to install a proper outlet.
1. The water heater is designed to be connected to 220V single-phase
electric main. Prior to connecting make sure that parameters of the
electric main in the place of connection correspond to parameters,
specified on the identification plate with technical parameters of the
appliance. You should follow the current electrical safety code when
installing the water heater.
2. The power outlet must be properly grounded. The outlet must be
designed for rated current not less than 10A, electric cable with copper
core must have cross section not less than 3x1.5 mm2 (for copper).
The power outlet and plug must always be dry to prevent current
leakage. Regularly check if the power plug is tightly connected to the
outlet. Do it in the following order: insert the power plug into the
outlet, switch off the water heater after half-hour operation and unplug
the cord,
check if the plug is heated by your hand. If the plug is heated
over 50°C, then to prevent damages, accidents and fire as a result of bad
electrical contact, replace the outlet with a new one. A specialist must
do this.
5. Water heater with the mounted valve must be connected to the water
main install a shut-off valve at the water inlet point. You need to connect a
drain pipe to the opening of the pressure relief of safety valve. Next you
should put a drain pipe to the sewer.
6. Connect the desired number of consumption points to the outlet nozzle,
marked red.
7. Open the shut-off tap and one of the tap assemblies. After the tank is
filled with water, as evidenced by issue of water from the cock assembly,
shut the cock assembly and check the leak integrity of all joints.
NOTE:
The water heater is an appliance, operating in such a manner that
pressure of water in the water heater corresponds to the pressure of
water in water main. If pressure in the main exceeds 0.75 MPa, then it is
necessary to mount a pressure reducer before the water heater so that
pressure doesn't exceed 0.7
5 MPa.
www.timberk.com e lectric storage water heater