Timberk SWH MS210H, Инструкция по эксплуатации

Страница: 12 / 32

12 www.timberk. electrical storage water heater com
9. MAINTENANCE
Fig . 1 6
Depressurization hole
Drain knob
Screw
Fig . 1 8
Fig . 1 7
1. Check the power plug and outlet as often as possible. Secure electrical
contact and also proper grounding must be provided. The plug and outlet
must not heat excessively.
2. If the water heater is not used for a long time, especially in regions with
low air temperature (below 0°C), it is necessary to drain water from the
heater to prevent damage of the water heater (due to water freezing in the
4. Preventive operations must be performed upon strict observance of
the operation manual and safety precautions.
5. The water heater is equipped with a thermal switch, which cuts off
power supply of the heating element upon water overheating or its
absence in the water heater. If the water heater is connected to the mains,
but water is not heated and the indicator doesn't light up, then the
thermal switch was switched off or not switched on. To reset the water
heater to the operating condition, it is necessary to:
- de-energize the water heater, remove the plate of the side / lower cover
for horizontal-type/vertical-type water heater respectively.
- for MS2 series horizontal-type water heaters: press the button, located
in the center of the thermal switch, placed near the heating element (with
a round shape), until it clicks, Fig.15;
- for RS1/RS2/RS7 series water heaters: unscrew retaining nut of the
thermal switch, fastened on the flange of the heating element, turn over
the thermal switch and press the button, located in the center of the
thermal switch, until it clicks, Fig. 16;
- if the button cannot be pressed and there is no clicking, then you should
wait until the thermal switch cools down to the initial temperature.
inner tank).
3. To ensure long reliable water heater operation, it is recommended to
regularly clean the internal tank and remove deposits on the electric
heating element of the water heater, as well as check condition (fully
decomposed or not) of the magnesium anode and, if necessary, replace it
with a new one in case of full decomposition.
Tank cleaning frequency depends on hardness of water located in this
territory. Cleaning must be performed by special maintenance services.
You can ask the seller for address of the nearest service center or find it on
the website www.timberk.com.
IMPORTANT!
The manufacturer provides an extended guarantee for particular
water heater components provided that timely and proper routine
maintenance is performed by specialists of an authorized service
center (see the guarantee card).
8. You can easily determine whether the appliance is heating water at a
particular moment or not. When water heating is active, the "HEATING"
indicator glows on the control panel. If this indicator is extinguished, water
heating is not performed.
9. To switch the working water heater off, turn the thermostat knob
counterclockwise up to the stop and set both switch keys on the control
panel to « » position. The water heater will stop operation. But if you do
not remove the plug from the receptacle at that, the "Timberk" indicator will
continue glowing on the control panel notifying you that the appliance is
still connected to the electric mains.
It is recommended to always disconnect the water heater from the electric
mains, if you do not plan to use the appliance for some time.