DEVICE DESCRIPTION (Fig. 3 and 4)
1.Control panel
2. Remote control receiver
3. Cool air outlet
4. Joint tube
5. Exhaust hose
6. Hot air filter
7. Hot air inlet
8.
Remote control location
9.
Hot air outlet
10. Filling the tank sensor
11.
Cool air filter
12.
Cool air inlet
13.
Water tank
14.
Drain hole
RU
T
imberk
.
Timberk
,
,
:
(
)
:
KZ
AK
BY
OS
TJ
UA
KG
CIS
,
c
10%,
.
(
)
.
4
21
www.timberk.com
electric floor standing air onditioner ortable type (single case)
www.timberk.com
(
)
Fig
. 3
Fig
. 4
Installation of air outlet hose (Fig. 5)
1. Prior to operation of the unit take off the removable cover and get the air
outlet hose, then insert it in the hole.
2. Rotate the air outlet hose in the direction, indicated by arrow 1 and take it
out from the removable grill.
3. Rotate the air outlet hose in the direction, indicated by arrow 2 and
connect it to the removable grill.
Fig
. 5
Installation of the hose in cooling / heating modes (Fig. 6)
To switch the air conditioner to heating it is necessary to install the hose to
the side, where cold air is coming out. To switch the air conditioner to
cooling it is necessary to install the hose to the side, where warm air is
coming out.
To switch the unit to the required mode (cooling/heating):
Disconnect the removable grill and the air outlet hose, as shown by the
arrow in Fig. 6 A, then interchange their position (B) and connect to the
unit. Final structure is shown in Fig.6 C.
Fig
. 6
(À)
(Â)
(Ñ)
