Timberk AC TIM 07H S10B, Инструкция по эксплуатации

Страница: 9 / 36

www.timberk.com • Electric air conditioner
9
7. OPERATING MODES
AUTO mode (SMART)
The auto mode is turned on and off with the use of the button “MODE” on
the remote control board.
1. While working in the AUTO mode, a microprocessor will automatically
select COOL, FAN, HEAT or DRY modes based on the difference between
actual and preset air temperature indoors.
2. If the AUTO mode does not provide comfort conditions, select the mode
manually. In automatic mode, depending on air temperature in the room,
the conditioner will select needed temperature parameters of its operation
in the following order:
Temperature indoors Automatic mode sele ction Automatically maintained temperature
if <20° С then HEAT mode shall be turned on 23° С
if <20° С - 26° С then DRY mode shall be turned on 18° С
if >26° С then COOL mode shall be turned on 23° С
In normal operation of the conditioner average service life of batteries will
be about a half-year.
Replace batteries, if command receiving is not confirmed with an audio
signal, or if the display does not show a sign of command transfer. When
generating commands from the remote control board, point an IR-radiator
at a remote-control signal receiver situated on the indoor unit. Hold the
remote control board at the distance of no more than 8 m from the indoor
unit.
COOL, HEAT and FAN
1. Turn the conditioner on pressing the "ON/OFF" button.
2. Pressing the "MODE" button, select COOL, HEAT or FAN mode manually.
3. Pressing the "TEMP" button (up-down), set the desired air temperature
indoors (except for FAN mode).
4.Pressing the "FAN SPEED" button on the remote control board, select
the fan rotation speed: AUTO, LOW, MIDDLE, HIGH, and the conditioner
will start working in accordance with the selected setting.
5.To turn the conditioner off, press the "ON/OFF" button once again.
In the FAN mode air temperature indoors is not set.
DRY
Turn the conditioner on pressing the "ON/OFF" button. Pressing the
"MODE" button, select the DRY mode. The conditioner will start working in
the set mode. To turn the conditioner off, press the "ON/OFF" button once
again. TURBO mode
When pressing the «TURBO» button on the remote control board, the
conditioner will start working in turbo mode – for maximum cooling (in cool
mode) or for maximum heating (in heat mode).
TIMER mode
Procedure of timing:
– If the conditioner is off, then press the “TIMER” button to activate the
automatic turning on. Pressing this button once again, set the time for
turning the conditioner on in the set time interval. To cancel the timer mode,
press the “TIMER” button once again.
–If the conditioner is working, then press the “TIMER” button to activate
the automatic turning off. Pressing this button once again, set the time for
turning the conditioner off in the set time interval. To cancel the timer mode,
press the “TIMER” button once again.
SLEEP mode
Button «SLEEP» (Night Care). Using this button, you may turn the sleep
mode on and off. Use this mode to reduce operation sound when sleeping,
etc.
Press the SLEEP button, the air flow sound from the indoor unit is
decreased.
Press the SLEEP button again can release the mode.
Regulation of treated air flow direction
Regulating the position of deflectors (blinds), set the direction of treated
air flow ensuring uniform distribution of temperature and the most comfort
conditions in the room. To change the position of deflectors, use the
«SWING» button.