Timberk 0
XTN
Z1, Инструкция по эксплуатации

Страница: 8 / 36

8 www.timberk.com i nstant water heater
5. SCOPE OF SUPPLY
1. Water heater 1 pc .
2. Mounting fittings 1 pc.
3. Operational
Manual 1 pc .
4. Warranty card 1 pc .
5. Packing 1 pc.
6 . INSTALLATION OF WATER HEATER
Location
1. Water heater can be installed in any place provided that the indoor
temperature is not lower than 0° .
2. Water heater is installed at the flat wall surface in strict parallel to the
floor with outlet nozzles in downward direction; it shall be installed
at a place where water and splashes cannot get onto its housing.
3. When water heater location is being defined, free access to it shall be
assured, not less than 0.3 m from the top, bottom and sides. It will
provide for the maximum convenient servicing and regulation of
water heater if required.
4. Water heater shall be installed in such a way that a distance from the
bottom part of the device to the floor does not exceed 1.6 m .
Mounting of Water Heater
WATERMASTER I Series. Water Heater Models: WHE 3.5 XTR H1, WHE 4.5
XTR 1, WHE 5.5 XTR H1
As shown in Figure 7, identify the points for openings and drill 2
openings of the corresponding depth in the wall, insert dowels, screw
up the screws, and make sure that there is a certain distance between
the screw head and the wall, then hang the water heater on the screws
(see Fig.8) and check the reliability of fixing.
Fig . 7
Fig . 8
NOTE :
Water heater installation at the place of its operation and electric
power connections shall be performed by the specialized organiza-
tion , a representative of the manufacturer ' s maintenance service or
experts licensed for execution of electric equipment assembling with
safety regulations observed .
In the event of violation of water heater operation manual, water
heater is not subject to warranty servicing, and the manufacturer
cannot be held liable.