Tim Sistem NIKA- HYDRO, Руководство пользователя

Страница: 10 / 28

IGNITION AND LIGHTING
Before the first firing, wipe all painted surfaces with a clean and dry cloth, in order to avoid
burning of impurities on the stove and creation of unpleasant smells.
Start the fire in the stove by following order:
• pull the primar air regulator handle counterclockwise to the maximum point
• secundary air regulator leave open untill the flame gets stabile and afterwards fire intensity
control wih regulator
• open the firebox door
• insert the firing material in the firebox (tiny chopped wood on dry wrinkled paper)
• light the fire
• close the firebox door,
• after creating a basic glow in the firebox, insert larger pieces of wood or coal,
close the firebox door and push the handle of the draft regulator to the stove
If fuel briquettes are used as a fuel, you must wait until entire amount of a fuel lightens up
and only then reduce draft on half
• when adding fuel,open the firebox door for just few degrees,wait for 4-5 seconds and
then slowly open them wide. Do not open the door suddenly, because when there is a high
flame in the firebox, it can could easily reach in to room.
Regulating the draft in the stove, you can regulate temperature, power and the combustion of
fuel. Recommended fuels are briquettes and wood.
You must not use gasoline and similar fuels, because by using liquid fuels you crate
conditions for damaging the stove and to provoce an explosion.
Attention!
• Do not use organic wasteas fuel, food residue, plastic, combustible or explosive materials,
which combustion disturbs the proper functioning of the cooker and may cause damage and
environmental pollution.
• Increased ambient temperature can cause poor air circulation (drafts) in the chimney, and in
that case is recommended more frequent firing in smaller quantities.