Operation - 16
GENERAL OPERATION
4. Remove the bearing adjustment mechanisms
(C). from both outer flange bearings.
5.
C
C
Locate the master link on the wheel drive
chains. Disconnect the master link to remove
the drive chains.
6. Loosen the bearing and sprocket set screws (D)
7.
D
D
D
D
Remove the 3/8” fender mounting bolts (E).
E
E
E
E
8. Remove the fender and wheel assembly from
the axle.
9.
Adjust the snap rings, sprocket, and woodruff
key (F) to the desired location. NOTE: When
adjusting the right side of the machine to the
narrow position the inner snap ring (G) will not
be used.
10.
F
F
G
G
Install the fender and wheel assembly onto the
axle.
11. Align the mounting holes and install the 3/8”
fender mounting bolts.
12. Tighten the bearing and sprocket set screws.
13. Install the drive chains.
14. Install the bearing adjustment mechanisms.
15. Adjust the chain tension in accordance with
the chain tension adjustment procedure in this
manual.
16. Install the belt and pulley cover.
17. Install the left and right axle covers.
