12
Note: All connections should be made with the remote isolation switch for the TileVision
®
set
to OFF.
Installing the TileVision
®
– Initial Connections
Earthing Points
Introduce the lower front edge of the unit into the back box
and fit the earth cables to the two earthing screws as
indicated by the green labels on the rear of the TileVision
®
.
The earth cables are electrical connections and
must not
be used to support the weight of the TileVision
®
.
Power Socket
The Power connector is located at the extreme left of the base connector array.
Speaker Connections
The supplied stereo speaker should be connected after the earthing straps are connected to the rear of the
TileVision
®
as detailed above.
The speaker terminals on the TileVision
®
and on the stereo
speaker are marked with coloured dots which match the
colours of the supplied four-core speaker cable. To ensure
that the stereo speaker is connected correctly the
individual leads should be connected to their matching
colours on both the TileVision
®
and the stereo speaker.
The speaker connection block is found on the left of the rear
of the TileVision
®
. Lift one of the lugs, push one conductor
of the speaker lead into the connector, release the lug and
give the lead a slight pull to make sure that it is gripped correctly. The other wires should be connected in
the same way.
If two separate speakers and alternative speaker cables are being used, the conductor with the stripe
should be connected to the negative terminal (L– or R–) and the plain conductor should be connected to the
corresponding positive terminal (L+ or R+). The connections to the speakers terminals should be made in
the same way – striped conductor to the negative terminal and plain conductor to the positive terminal.
Earth lead
connections
L–
L+
R+
R–
The speaker connection block
USB Memory Stick (Flash Drive)
If the timer recording, time shift recording functions, or the digital media player is to be used, a USB
memory stick (flash drive) must be installed.
