Straight cuts
l
Loosen the cutting guide clasps (Q) at both ends of the
cutting guide (A).
l
Set the cutting guide (A).
l
Relock cutting guide clasps (Q).
l
Place the piece of tile against the cutting guide (A) then
push the work piece towards the diamond wheel (H).
Diagonal cuts
l
Loosen the cutting guide clasps (Q) at both ends
of the cutting guide (A).
l
Set the cutting guide (A) to the distance required.
l
Relock the cutting guide clasps (Q).
l
Hook the angle guide (B) onto the cutting guide (A).
l
Choose the angle desired and tighten the bolt to secure
the angle guide (B) in conjunction with the cutting
guide (A).
l
Push the angle guide (B) together with the tile to be cut towards the diamond wheel (H).
Mitre Cuts (22.5
°
and 45
°
)
l
Lift up the water reservoir lid (D).
l
Pull out the two lid supports (L) located on the back
of the water reservoir lid (D).
l
To cut 22.5
°
angles, place the two upper 22.5
°
mitre
stays on the lid supports (L) into the two slots located
inside the water reservoir.
l
To cut 45
°
angles, place the two lower 45
°
mitre stays
on the lid supports (L) into the two slots located inside
the water reservoir.
l
Place the piece of tile facing down onto the water
reservoir lid (D) then push the work piece towards the
diamond wheel (H).
Using the Bench stops
l
Locate and place both of the bench stops (R)
underneath the front bottom legs on both left and right
ends.
7
