Service
Have your power tool serviced by a qualified repair person using only identical replacement
parts. This will ensure that the safety of the power tool is maintained.
Specific Safety Rules
Always connect to an electrical power point using an approved RCD circuit breaker. This is an
essential safety precaution.
For safety and to prolong the motor life only switch the tile cutter on before cutting a tile and
switch off immediately after use.
Only ever cut one tile one time.
Keep water clear off the electrical parts of the tool and away from persons in the working area.
Always use blades correct in size and arbor shapes. Blades that do not match the mounting
hardware of the saw will run eccentrically causing loss of control.
Never use damaged or incorrect blade washers or bolts. The blade washers and bolts are
specially designed for your saw to ensure optimal performance and safety of operation.
Tool Precaution
Make sure the tool is connected to the voltage marked on its name plate.
Always wear hearing protection, safety glasses and dust mask.
Never touch the moving parts or the blades during use.
Never start the tool when its rotating components are in contact with the work piece.
Check the blade carefully to see if cracked or damaged before use. If cracked or damaged,
replace it immediately.
Keep the cord away from the cutting area and position it so that it will not be caught on the
work piece.
Unpacking
The tile cutter comes partially assembled for packaging purposes. Lay the parts on the bench
and check against the parts list.
-
1Pc x Cutting guide
-
1Pc x Angle cutting guide
-
1Set x Splash guard assembly
(1Pc x Splash guard, 1Pc x Metal plate, 1Pc x Locking bolt, 1Pc x Nut)
-
1Pc x Diamond wheel
-
2Pcs x Spanners (holding spanner and tightening spanner)
-
2Pcs x Bench stops
Once it has been established that all parts are correct proceed assembling as below.
4