TIL TiL-92-SC, Инструкция по установке и эксплуатации

Страница: 27 / 44

TECHNISONIC INDUSTRIES LIMITED
www.til.ca
TSR-4100 92-SC Installation & Operating Instructions TiL 93RE125 Rev F
3-1
SECTION 3 – OPERATING INSTRUCTIONS
3.1 INTRODUCTION
This section includes a functional description of each switch, control, indicator and connector
located on the front and rear panels of the Single Channel Receiver.
3.2 INSTALLATION
The Single Channel Receiver is designed for mounting in a 19 inch rack. An AC Line cord P/N
927002-1 is supplied for connection to AC Power. A 9 Pin connector (mates with Positronic
GM9MSCG000VL or equivalent) and a 25 Pin Connector (mates with Amphenol 17D-B-25S or
equivalent) are provided for connection with external DC and 2 Wire 600 ohm dedicated lines. A
50 ohm "N" Type connector is provided for connection to an external antenna. Refer to Section 2
for frequency selection and remote audio setup details.
(1)
Mount Receiver in 19 inch rack with 4 screws.
(2) Ensure that Receiver POWER ON/OFF switch is set to OFF.
(3) Install AC line cord in AC chassis connector on rear panel.
(4) Install Remote Control connector to 9 Pin or 25 Pin connector as required. (Refer to
Figure 3.1 for connector pin outs.)
(5) Connect antenna connector to rear panel chassis N Type connector.
3.3 OPERATOR'S SWITCHES, CONTROLS AND INDICATORS
A view of the front and rear panel is given in Figure 3.1. A functional description of each of the
operator's switches, controls and indicators are given in Table 3.1, Operator's Switches, Controls
and Indicators.