
TECHNISONIC INDUSTRIES LIMITED
RC-9000 Operating Instructions
TiL 13RE481 Rev. C
6
2.12 ESW(0) KEY (Ergo Switch Key)
The ESW key provides the function of the concentric or ‘ergo’ switch on the portable. The switch
has two conditions which are represented by ‘O’ and ‘
∅
’. Pressing the ESW key toggles the
condition back and forth. The condition is displayed at the right hand side of the display line
(second character from the right). The ergo switch condition is saved when the unit is turned off.
There are separate conditions for each band installed. The ESW key can be programmed with
the CPS™ to a variety of functions such as low power, scan and secure, or encrypted mode.
2.13 TSW(*) KEY (Toggle Switch Key)
The TSW key provides the function of the toggle switch on the portable. The switch has three
conditions which are represented by ‘A’, ‘B’, and ‘C’. Pressing the TSW key toggles the condition
A,B,C,A,B, etc. The condition is displayed at the far right hand side of the display line (last
character on the right). The toggle switch condition is saved when the unit is turned off. There are
separate conditions for each band installed. The TSW key can be programmed with the APX
CPS™ to a variety of functions such as low power, scan, zone select, or pl disabled mode.
2.14 DISPLAY
The transceiver has full colour LCD display. The zone name, channel name, condition symbols
(scan, direct, call, secure, monitor, etc.), and switch settings will be displayed for each module.
The active band as selected by the soft keys will be highlighted. The bottom line displays the
menu items associated with the module selected and the mode of the knob.
2.15 GENERAL OPERATION
Switch on the RC unit by momentarily pressing the knob. Select the desired band by pressing one
of the band select keys on the left of the display. Press the knob again to show CHAN on the
bottom right of the display. Rotate the knob until the desired channel or talk group is selected.
Press the knob until VOL is again shown on the display. You can adjust the volume by waiting
until a signal is received or by pressing F1 (factory programmed for monitor function) and
adjusting the rotary knob. The radio is ready to use. If the radio is installed in separate mode,
remember that the band selected by the soft keys is what menu is displayed on the screen but the
band selected by the audio panel is the band that you are transmitting and receiving on. To use
the DTMF keypad while transmitting, the band you are using must be selected on the display. If
the radio is installed using both of the combined input/outputs, then pressing the MODE key will
alternate the display between the two users.