TECHNISONIC INDUSTRIES LIMITED
www.til.ca
AMS-6000 Installation and Operating Instructions
TiL 03RE325 Rev n/c Issue 5
3-2
3.3.2 Separate Mode
In this mode, the TDFM-600/6000 and AMS-6000 will be connected to two or three
positions on the existing audio panel. The ‘Y’ harness is used to connect the TDFM-
600/6000 transceiver to the AMS-6000 as well as to the aircraft audio system. The aircraft
harness shall be wired as if it were to be plugged directly into the TDFM-600/6000 but
instead will be plugged into the third connector on the ‘Y’ harness.
28Vdc Power to the
Transceiver is supplied directly via a separate 5A fused connection.
See Table 3-2, Figure 3-
2 and Figure 3-4.
FIGURE 3-2
Separate Mode Installation
3.4
AMS-6000 15-PIN CONNECTOR PINOUTS (J2)
The following are the pinouts for the 15-pin connector (J2) and the function of each pin.
Pin #
Description
1 600
Ohm
Output
2 No
Connection
3
Panel Lighting (28VDC or 5VAC)
4 Memory
UP
5 Memory
Down
6
Mic Signal Input
7 Main
Power
+28VDC
8 Main
Ground
9
4 ohm Speaker Out
10
4 ohm / 600 ohm output ground
11 No
Connection
12 No
Connection
13
PTT (Ground Keying)
14 Main
Power
+28VDC
15 Main
Ground
TABLE 3-1
Wire connections on a 15-Pin MALE D Connector (J2)
