TigerStop TigerSaw Miter, Руководство пользователя

Страница: 14 / 52

8
Resetting the Safety Chain
Interconnect Behavior
There are two steps to reset the safety chain:
1. Rotate the E-stop button on the saw (
pg. 5 ) clockwise
until it pops out.
2. Pull the blue knob of the kill line switch. It should click into
place.
• If the blue knob won’t lock into place, adjust the kill line tension
( pg. 29 ).
The AIK2 can behave in multiple ways. These options can be selected with the TIK (Tool Interconnect Kit) setting ( pg. 19 ).
Integration & Automation
The safety chain is now active, allowing the system to be powered up.
The state of the safety chain is indicated by four LEDs on the safety
relay, visible through the circular window on the safety box (right).
From top to bottom:
• Power into the safety relay
• Power across the safety relay
• Safety chain circuit 1
• Safety chain circuit 2
There are three options:
1. Full Auto: Both cutting and positioning are automated.
• This is the standard setting for the TigerSaw Miter.
• The operator selects a pusher list, loads stock, and starts the process.
• The system automatically pushes and cuts until the entire stock piece is processed.
• The operator loads the next stock piece.
2. Advanced: Only positioning is automated.
• The operator selects a pusher list, loads stock, and starts the process.
• The system automatically positions the stock for the next cut.
• The operator cycles the saw.
• The previous two steps repeat until the entire stock piece is processed.
• The operator loads the next stock piece.
3. None: Every motion is initiated by the operator.