10 | Automate
™
Programming Instructions | Flush Wall Switch
.
Check motor direction
6.1
Damage to shade may occur when operating motor prior to
setting limits. Attention should be given.
Reversing motor direction using this method is only possible
during initial set-up
Direction change will not occur if switch is locked.
See Section 6.3.
To check travel direction of shade, press
UP or
DOWN on controller.
Quick Press = Step
Long Press = Continuous Travel
To reverse shade direction, hold both
UP and
DOWN.
Until the motor responds.
Approx.
Motor Response
IMPORTANT
IMPORTANT
6
INITIAL SET UP
SECS
5
Set Limits
6.2
Cycle shade up and down prior to setting limits to settle fabric
For FT Motors, the bottom limit should be set ~ 1.38 in. (35mm) below the Ultra-Lock to disengage the auto lock mechanism when the shade is
raised.
After setting limits, motor will automatically exit from initial
set-up mode.
Move shade to the desired highest or lowest
position by pressing the
UP or DOWN buttons
on controller.
To save upper limit, hold
UP and STOP.
To save lower limit, hold
DOWN and STOP.
Motor Response
IMPORTANT
IMPORTANT
Initial set-up is not complete
IMPORTANT
Approx.
TIGER WINDOW FASHIONS
