TIGA Junio, Руководство пользователя

Страница: 25 / 40

Need replacement parts?
Take advantage of our online pricing policy at ;
www.rgklife.com
User Manual
Issue No: 16 | 2016
25
Procedure 5
This procedure includes the following: Replacing the Hand Rim; Repairing/Replacing rear wheel, tyre/tube;
WARNING:
If a handrim should become damaged it could lead to
injury, and should be replaced.
Handrim replacement
1. Remove the rear wheel from the chair by depressing the
detent/RGK button.
2. Remove all air from the tube by pressing down on the pin
in the centre of the valve stem
3. While carefully holding the tyre, tube and rim strip to one
side, hold the allen head screws and remove the locknuts
that secure the handrim to the rear wheel.
4. Remove the existing handrim.
5. Install the NEW handrim by reversing the above
procedures.
6. Inflate the tyre to the correct psi rating on the sidewall of
the tyre.
7. Reinstall rear wheel to the chair.
8. Repeat the procedure for the opposite rear wheel if
necessary.
NOTE:
It is not necessary to remove tyre and tube when replacing
hand rim on either Spider or X-Core Wheels.
User Manual | Procedure 5
Repairing / replacing rear wheel, tyre & tube
1. Remove the rear wheel from the chair..
2. Remove all air from the tube by pressing down on the
pin in the centre of the valve stem.
3. Unscrew the valve securing ring (Presta valves only).
Using tyre levers, remove outside tyre bead from wheel
rim, unscrew valve securing ring (Presta valves only)
remove tube. Remove tyre from rim. Reverse procedure
to fit tyre/tube.
4. Inflate the tyre to the correct psi rating on the side wall
of the tyre.
5. Reinstall rear wheel to the chair.
6. Repeat the procedure for the opposite rear wheel if
necessary.
NOTE:
If replacing the rear wheels or tyres with a different size
than what was originally on the chair please note this
will raise or lower the rear of the chair and may have an
adverse effect on your balance.
Please contact your dealer or mobility advisor for
additional advice.
WARNING:
Tyre MUST be deflated before any disassembly procedures
are performed.
WARNING:
DO NOT inflate tyre until it is completely assembled.
WARNING:
Make sure the detent/RGK button of the quick release
axle is fully released BEFORE operating the wheelchair.