9
Adjust the battery position and
attach the batteries:
• Rotate the battery mount down at
least 45º.
• Attach both batteries onto the
battery mounts.
In the Flyer-LE
™
, both battery mounts
are active. You can choose 12 volts only
with both batteries in parallel, or 12 and
24 volts – with the batteries in series, via
the two-position switch.
Dock the sled in the docking
bracket:
• Hold the sled upright, with the
monitor (front) facing to the left.
Place the center post into the
bracket so the bottom of the stage
rests on the yoke.
• Push the aircraft pin back through
the yoke, securing the post in the
bracket.
Remove the dovetail from the
stage and set aside:
• Loosen the dovetail locking knob
about one half turn. (If you unscrew
this knob all the way the spring
may pop out.)
• Safety stops on the dovetail and a
safety catch on the sled keep the
dovetail from sliding off the stage
when the dovetail locking knob is
loose.
• Pull the dovetail to the back of the
stage until the safety catch stops
it.
• Pull the safety catch down and
slide the dovetail out of the stage.
• Make sure the safety catch springs
back into its position when the
dovetail is out.
• Take a moment to look at the stage
adjusting mechanism.
• Turn the fore/aft knob. The pinion
engages with the rack on the
dovetail plate.
• Turn the side-to-side adjustment
knob.
safety catch
safety catch
dovetail lock
pinion
fore and aft
adjustment knob
side to side
adjustment
knob
use a small screwdriver
to access the switch
