Tiernan TDR60, Инструкция по установке и эксплуатации

Страница: 8 / 92

vi 01-0868-401B 12/02 Preface
Provide Adequate Ventilation
Slots and openings on the TDR60 are provided for ventilation that is needed to ensure reliable
operation. To avoid overheating and ensure that the ventilation slots are not blocked, place the
TDR60 on a smooth, hard surface that has at least two inches of clearance around the unit and
adequate air circulation. If the equipment is placed in a closed area, such as a rack, ensure that
proper ventilation is provided and that the internal rack operating temperature does not exceed the
maximum rated temperature at the position of the TDR60.
Never place the TDR60 on a soft surface that would obstruct the required airflow into the ventilation
slots.
Use Correct Power Source
For units equipped with a North American power cord, the cord has an IEC-compatible female plug
on one end, and a male plug on the other end. This cord is UL and CSA approved up to 125 VAC at
10 A and is ready to use with no user wiring required.
For units equipped with an International power cord, the cord has an IEC-compatible female plug on
one end, and three stripped and tinned bare wires on the other end. This cord is approved up to
250 VAC at 6 A and complies with the international color codes of green/yellow (ground), blue
(neutral), and brown (line).
If these color codes do not correspond to the colored markings on the terminals in the plug, use the
following standards:
■
The green/yellow wire must be connected to the plug terminal marked by the letter E or by the
earth symbol (
) or color-coded green and yellow.
■
The blue wire must be connected to the plug terminal marked with the letter N or color-coded
black.
■
The brown wire must be connected to the plug terminal marked with the letter L or color-coded
red.
An AC plug must be attached to the International power cord in accordance with government
standards and codes in effect at the installation site. If an unterminated power cord is supplied with
the unit, the appropriate certified termination plug must be installed. The following is a list of the
required certifying agencies for various countries.
Apparaten skall anslutas till jordat uttag när den ansluts till ett nätverk.
Route Power Cords Safely
Route power cords so they are not walked on or pinched. Pay particular attention to cords and
connections at the plugs, receptacles (such as power strips), and the point where they exit from the
TDR60 and attach to other equipment. Do not place any items on or against power cords.
No Stacking
Do not place or stack any objects on top of the TDR60. Other equipment may be placed in a rack or
on a shelf above or below the TDR60, but never stacked directly on top of it.
Country Agency Country Agency
Australia SAA Italy IMQ
Austria OVE Japan MITI
Belgium CEBEC Netherlands KEMA
Canada CSA New Zealand SECV, SECQ, SECWA, EANSW, ETSA, HECT,
Denmark DEMKO Norway NEMKO
Finland FEI Rep. S. Africa SABS
France UTE Spain AEE
Germany VDE Sweden SEMKO
India ISI Switzerland SEV
Ireland IIRS United Kingdom ASTA, BSI
CAUTION!
Please Read
Carefully