3
READ THIS PAGE FIRST
X
Read this manual thoroughly to become familiar
with the device and its capabilities before installing
or operating your water softener. Failure to follow
instructions in this manual could result in personal
injury or property damage. This manual will also
help you to get the most out of your softener.
X
This system’s installation must comply with all state
or local regulations. Check with your local public
works department for plumbing and sanitation
codes. In the event the codes conflict with any
content in this manual the local codes should
be followed. Consult your licensed plumber for
installation of this system.
X
This water filter is designed to operate on pressures
of 30 psi to 125 psi. If the water pressure is higher
than the maximum use a pressure reducing valve in
the water supply line to the filter.
X
This unit is capable of operating at temperatures
between 40°F and 100°F (4°C - 37°C). Do not use
this water filter on hot water supplies.
X
Do not install this unit where it may be exposed
to wet weather, direct sunlight, or temperatures
outside of the range specified above.
X
Avoid pinched o-rings during installation by
applying (provided with install kit) NSF certified
lubricant to all seals.
X
Filters are commonly exposed to high levels of
iron, manganese, sulfur, and sediments. Damage
to pistons, seals, and or spacers within the control
valve are not covered in this warranty due to the
harsh environment.
X
It is recommended to regularly inspect and service
the control valve on an annual basis. Cleaning
and or replacement of piston, seals, and or spacers
may be necessary depending on how harsh the
conditions are.
X
Do not use water that is microbiologically unsafe
without adequate disinfection before or after this
system.
X
This publication is based on information available
when approved for printing. Continuing design
refinement could cause changes that may not be
included in this publication. The manufacturer
reserves the right to change the specifications
referred to in this literature at any time, without
prior notice.
BEFORE STARTING INSTALLATION
INSTALL NOTES &
SAFETY MESSAGES
Watch for the following
messages in this manual:
NOTE
Do not remove or destroy
the serial number. It must be
referenced on request
for warranty repair or
replacement
NOTE
:
used to
emphasize installation,
operation or
maintenance information
which is important
but does not present a
hazard.
CAUTION:
used
when failure to follow
directions could result in
damage to equipment or
property.
WARNING
:
used to
indicate a hazard which
could cause injury or
death if ignored.
▶
▶
▶
▶
CAUTION!
Disassembly while under
pressure can result in flooding.
▶
!
WARNING
!
ELECTRICAL SHOCK HAZARD!
Unplug the unit before
removing the cover or
accessing any internal control
ports.
▶
