TIE DOWN
Safety Products Division
800-241-1806 • 404-344-0000 • www.tiedown.com
E1805, Rev. 10/12/21
7
Hatch Rail System
Cross Over Bracket installation
20”
40”
Tools needed for this step:
5/16” Hex Key
Tape Measure
Hardware required for this step:
Qty.
Cross Over Bracket (J)
7
Slide cross over brackets over vertical post as shown in
Fig 7-1. The lower cross over bracket should be
positioned approximatively 20 in. from the bottom of the
corner mounting bracket. Lightly tighten the 3/8” nut on
the cross over bracket.
The top cross over bracket should be positioned
approximatively 40 in. from the bottom of the corner
mounting bracket. Lightly tighten the 3/8” nut on the
cross over bracket.
Repeat the cross over bracket assembly for the remaining
vertical posts. Do not tighten brackets.
Fig 7-1
Fig 7-2
