TIE DOWN
Roofing Products Division
800-241-1806 • 404-344-0000 • www.tiedown.com
5
Roof Cart Assembly
Step 7
Flat Washer (#7)
Cotter Key
(#8)
Cotter Key &
Washer (#8/#7)
Handle/Brake
Assembly (#5)
IMPORTANT: Side view of the handle brake assembly with the wheel brake bar (on the bottom side).
Steering Lock Position Holes
Handle Pin (#17)
Bushings (#16)
Wheel Brake
Bar
Step 7
Flat Washer (#7)
Cotter Key
(#8)
Cotter Key &
Washer (#8/#7)
Handle/Brake
Assembly (#5)
IMPORTANT: Side view of the handle brake assembly with the wheel brake bar (on the bottom side).
Steering Lock Position Holes
Handle Pin (#17)
Bushings (#16)
Wheel Brake
Bar
Step 7
Flat Washer (#7)
Cotter Key
(#8)
Cotter Key &
Washer (#8/#7)
Handle/Brake
Assembly (#5)
IMPORTANT: Side view of the handle brake assembly with the wheel brake bar (on the bottom side).
Steering Lock Position Holes
Handle Pin (#17)
Bushings (#16)
Wheel Brake
Bar
Step 5
Lift the front or the rear cart (may require two people).
Slide the flat free tires onto the axle.
Install a washer over the axle shaft, insert cotter key
through the axle mounting hole.
Split the cotter key securing the tire to the axle frame.
Repeat for all four tires.
Step 6
Install and split open cotter key on ONE end of the
handle pin (#17), slide on ONE washer.
Insert the handle pin through the handle guide
bracket on the front axle. Slide one bushing over
the handle pin.
Position the handle assembly so the wheel brake
bar is located on the bottom.
Align the handle assembly with the handle pin/
bushing.
Slide the handle pin with bushing through the
handle assembly tube while aligning the second
bushing with the handle pin.
Once the handle pin is aligned with the second
bushing, slide the entire assembly through the
opposite handle guide bracket. Slide on a flat
washer, install and split open the cotter key.
Step 7
The Penetrator Roofing Cart has the option of locking the
steering with a pull pin (both sides).
To lock the front steering: place the pull pin into the smaller
inside round hole.
