Tidland Class I, Руководство пользователя

Страница: 19 / 58

OPERATION
www.maxcessintl.com Tidland Performance Series Manual Knifeholder MI 557416 1 Q Page 19
Knifeholder
Pneumatic Lock
Ensure that:

anvil rings are in the desired slit position.

blade cartridge is securely locked to the control body.

air supply is attached and set to minimum pressure required
to slit your web material.
1. Adjust depth control knob so that it extends from the control body:
Class I
– 5/16" Class II and III – 1/2"
DO NOT SCREW the depth control knob all the way into the
body. There will be no travel during cartridge extension.
2. Toggle the actuator switch up to retract the blade cartridge.
3. Pull up on the traverse knob.
4. Turn the traverse knob to move the knifeholder along the guide
bar until knife blade is close to, but not touching, the cut side of the
corresponding anvil ring.
Ensure that the knife blade is not directly over the anvil ring
in order to prevent damage by collision when the blade
cartridge is extended in the next step.
Setup
5. Press and hold one of the two cartridge setup buttons, and then
toggle the actuator switch down to extend the blade cartridge.
6. Release the setup button after the cartridge is extended
and has completed its side stroke. The knifeholder will remain
in this position until the cartridge is retracted.
7. Traverse the knifeholder along the guide bar until the knife blade and the anvil ring lightly contact.
8. Press down on the traverse knob to lock knifeholder to guide bar. Make sure that the knifeholder
remains perpendicular to the guide bar and that the knife blade and anvil ring make contact.
9. Observe the overlap of the knife blade and anvil ring.
If the overlap is correct ― .030" (0.8 mm) ― the knifeholder is ready to slit: go to Step 11.
If overlap is incorrect, continue with Step 10.
10. Toggle the actuator switch up (retract) to make any blade overlap adjustments.
To increase the overlap, turn the depth control knob counterclockwise.
To decrease the overlap, turn the knob clockwise.
Note: One click increases or decreases the overlap .004" (0.1 mm).
One complete turn increases or decreases the overlap .040" (1.0 mm).
DO NOT SCREW the depth control knob all the way into the body. There will be no travel
during cartridge extension.
11. Toggle the actuator switch up (retract).
Note: If the blade cartridge is not retracted after completing the setup and before slitting, the
knifeholder will not function as designed and may result in poor slit quality.
Operate
12. Toggle the actuator switch down (extend) to begin slitting operation.
TRAVERSE KNOB
DEPTH CONTROL
KNOB
ACTUATOR
SWITCH
SETUP
BUTTONS
CONTROL BODY