Tico Pro-Spotter, Руководство по обслуживанию

Страница: 95 / 211

PRO-SPOTTER FRONT AXLE & STEERING
TICO Manufacturing
Service Manual 6-3
DRAG LINK
Removal
See Figures 6-2 and 6-3.
1. Park and prepare tractor for service. (See “Park
Tractor Safely” on page 1-3.)

WARNING
2. Using an appropriate lifting device, raise the front
end of the tractor. (See “Use Lifting Equipment
Safely” on page 1-4.)
3. Support the tractor using jack stands. (See “Support
Tractor Securely” on page 1-3.)
NOTE
Preventing the steering wheel from rotating will make the
steering gear box alignment easier.
4. Lock steering wheel into place.
Figure 6-2: Drag Link (front)
5. Remove cotter pin (1), nut (2), and drag link end (3).
Figure 6-3: Drag Link (rear)
6. Remove cotter pin (5), nut (6), and drag link end (7).
7. Remove drag link (4).
8. Repair or replace components as necessary.
Inspection
• Check all threaded components for damaged or
stripped threads. Repair light damage with thread
chasers. Replace parts found to be unserviceable.
• Clean all parts of dirt and debris.
• Inspect parts for wear or damage. Replace as
needed.
Installation
Installation is the reverse of the removal procedure.
• Perform wheel alignment. (See “FRONT END
ALIGNMENT” on page 6-5.)
• Prevent possible crushing injury or death.
Use appropriate lifting device.
• Support the tractor using properly rated jack
stands. Never work under a tractor supported
only by a jack.
• Do not use wood or concrete blocks to
support the tractor. Failure to properly
support the tractor may result in death or
serious injury.
1 Cotter Pin 3 Drag Link End
2 Nut 4 Drag Link
1
TPS-157
2
3
4
4 Drag Link 7 Drag Link End
5 Cotter Pin 8 Steering Arm
6 Nut
8
TPS-158
5
7
6
4