Tico Pro-Spotter, Руководство по обслуживанию

Страница: 90 / 211

5-6 Service Manual
TICO Manufacturing
TRANSMISSION PRO-SPOTTER
Installation
1. Lubricate and install new O-rings (5 and 6) on lube
and main filter covers (1 and 2).
2. Lubricate O-ring inside filters (7).
3. Push filters onto filter covers.
4. Install new gaskets (4) onto filter covers and align
holes in the gaskets to the holes in the covers.
IMPORTANT
Prevent possible damage to threads. Do not use the
cap screws to draw in filter covers. Push the
assemblies in by hand to seat the seals before
installing cap screws.
5. Install filter and filter cover assemblies into filter
compartment. Push the assemblies in by hand to
seat the seals.
6. Install cap screws (3) and tighten to specification.
7. Check transmission fluid level. (See “CHECK FLUID
LEVEL” on page 5-2.)
8. Fill transmission fluid as necessary. (See
“Transmission Fluid Filling” on page 5-7.)
For additional information, see the Allison Transmission®
operator’s manual.
TRANSMISSION FLUID
MAINTENANCE
Transmission Fluid Draining
See Figure 5-8.
NOTE
Transmission fluid does not require draining if only filters
are being replaced.
1. Ensure transmission fluid has reached a normal
operating fluid temperature of 71°—93°C (160°—
200°F).
2. Park and prepare tractor for service. (See “Park
Tractor Safely” on page 1-3.)
3. Disconnect battery cables. (See “BATTERY” on
page 3-3.)
Figure 5-8: Drain Plug
4. Position a suitable container under the transmission
drain plug (1).

CAUTION
NOTE
.
Transmission fluid should be drained while still at normal
operating temperatures. Hot fluid flows quicker and
drains more completely.
Specification
Cap Screw—Torque
51—61 N·m
38—45 lb·ft
1 Drain Plug
Avoid injury and serious burns from draining
transmission fluid. Avoid contact with hot
transmission fluid.
1
TPS-073