DW-‐DS1101 User guide.
DSP Wireless Inc. © 2013 All Rights Reserved.
www.dspwi.com
V1.0
DW-‐DS1101 Device Server Description -‐
The DW-‐DS1101 is an Ethernet-‐to-‐RS232 converter or Device Server that is manufactured by Tibbo Technology Inc.
for DSPW. DSPW units run a custom version of firmware and are tested with the appropriate end user equipment.
e.g. if you have purchased a DW-‐DS1101 that is configured for the Stewart Audio AV25-‐2-‐RS232, the DW-‐DS1101
that is shipped to you will have been tested with the Stewart Amp.
DW-‐DS1101 has one 10/100 BaseT RG45 connector, one DB9 connector with signals mapped to 3 TxRx RS232 ports,
and optional WiFi.
Indicators -‐
DW-‐DS1101 has
green
and
yellow
Ethernet status LEDs. Ethernet status LEDs indicate the following:
•Link/Data LED (green) is turned on when "live" Ethernet cable is plugged into the device. The LED blinks
whenever an Ethernet packet is received.
•100BaseT LED (yellow) is turned on when the device links with the hub at 100Mb. The LED is off when the link
is established at 10Mb.
If optional WiFi is installed then there are 5 Blue LEDs that indicate WiFi Rx signal strength.
OLED Display –
The 96x32 monochrome OLED display is used to display system status information. The display will be on during
power-‐up initialization and then will turn off to preserve display lifespan. To turn on again, press the Setup Button
to see the IP number setting. Press the Setup button again to cycle thru the system setup info screens.
Power Connector-‐
The power jack accepts power connectors with 3.5mm diameter. To maintain your warranty you must use a power
adaptor supplied by DSPW. DSPW power adapter provides 12VDC nominal output voltage, current 500mA.
On the power jack, the ground is "on the outside", as shown on the figure below.
