10-5
ZR Owner’s Manual
OM0005_Rev A_ZR
CHAPTER 10: WHEEL LOCKS
Pull to Unlock
Pull to Unlock
Push to Lock
Push to Lock
Figure 10-8
Standard Handle Positions 1, 2 and 3 (Locked)
Figure 10-9
Standard Handle Positions 1, 2 and 3 (Unlocked)
Figure 10-10
Reverse Handle Positions 1, 2 and 3 (Locked)
Figure 10-11
Reverse Handle Positions 1, 2 and 3 (Unlocked)
1
2
3
1
2
3
1
2
3
1
2
3
Standard Handle Positions 1, 2, 3
The Uni-Lock ships with the handle in Standard Position 3. If you desire to switch to Standard Positions 1 or 2, follow
the procedures below.
Tools Needed:
•
1/8” Allen Wrench
•
3/8” Open End Wrench
1. As shown in Figure 10-12, the wheel lock handle attaches to the wheel lock handle base with two Allen screws.
There is only one hole in the wheel lock handle base through which to attach the upper Allen screw. There are
three holes in the wheel lock handle base through which to attach the lower Allen screw.
2. Remove the lower Allen screw and locknut that secure the wheel lock handle to the wheel lock handle base.
3. Loosen, but do not remove, the upper Allen screw that secures the wheel lock handle to the wheel lock handle
base.
4. Reposition the wheel lock handle to the desired Standard Handle Position 1, 2 or 3 (see Figures 10-8 and 10-9)
and replace the Allen screw and locknut.
5. Securely tighten both Allen screws and locknuts.
Figure 10-12
Removing the Wheel Lock Handle
Allen
Screws
Handle
Base
Locknuts
