ThyssenKrupp TW63, Руководство по эксплуатации

Страница: 20 / 60

O
PERATING
M
ANUAL
TW63
T
ECHNOLOGY
ThyssenKrupp Aufzugswerke GmbH
3.3 Dimensions of machine base frame (optional)
Setup
To isolate the body, the machine base frame is placed on isolation elements.
These differ according to the type of mounting:
a) Rubber block 100 x 100 x 50 high without support
for mounting the machine on the machine room floor without a cement floor
or directly surface mounted on the cement floor.
b) Rubber block same as a) but with additional support 140 x 140 x 80 mm
high
For setup on a cement floor, support cast in cement floor.
(floor covering thickness
≤
60 mm)
Mounting the base frame
Loosely bolt together base frames supplied as single parts in the machine
room. Make sure that the supports are mounted with additional drilled holes
(2 holes) and pulley support on the correct side. Mount and secure the
deflecting pulley with axle on the pulley supports.
Place and align the base frame on the isolation elements according to the
plan of installation.
Use lifting gear to place the machine on the base frame; the traction sheave
must be on the deflecting pulley side. Move the machine sideways on the
base frame until the required
ASL dimension (parallel gap between the ropes
at the rope departure) is reached. Bolt the machine onto the base frame.
Align the traction sheave and deflecting pulley as parallel. Balance out
uneven surfaces by inserting the enclosed shims. The machine housing must
not be tensioned. Tighten the screws with the prescribed torque. See chapter
9. Plumb the rope departure on the rope pulley at the elevator car and/or
mounting on the car and counterweight.
Important: With a side or oblique rope departure, the gear box casing on the
machine base frame is to be secured by means of car steady plates with set
screws.
The versions can be found in the general arrangement drawing.
The arrangement of the suspension ropes in the suspension plates,
on the traction sheave as well as the rope pulleys should be as
symmetrical as possible.
20 09-2012