7
PAINTING THE SPEAKERS
If you intend to paint the speakers, it is best to do so before installation.
1) Remove the speaker grille.
2) Mask the baffl e.
3) After painting, carefully remove the paint mask.
Note:
Custom paint and grilles are available for an extra charge.
PREPARING FOR INSTALLATION
Map out the wiring paths from the speakers to the amplifi er. We recommend 16-gauge wire for
runs up to 25 feet, and 14-gauge wire for longer runs. Be sure the speaker wire does not rest or
rub against any sharp or pointed objects.
The speakers should be mounted on a fl at surface to form a good seal between the speaker
fl ange and the mounting surface.
When connecting more than two speakers per amplifi er channel, you should use series/parallel
wiring. In all cases, make certain that the total impedance does not fall below the amplifi er’s
rating. If you are not sure, contact your Snell Acoustics dealer.
You will Need:
1) A utility knife, an electric jigsaw, or other means of cutting a hole in the mounting surface.
2) A #2 Phillips screwdriver.
3) A wire cutter or stripper for preparing the speaker wires.
With the supplied hardware, the speaker can be installed in existing walls or ceilings from 1/2”
(12mm) to 1
1
/
2
” (38mm). For thinner walls, you will need to use spacers for the mounting legs
(Contact your Snell dealer for this optional rubber part).
IW-B7, C7 and IW-SR30.indd 7
IW-B7, C7 and IW-SR30.indd 7
7/18/08 12:38:13 PM
7/18/08 12:38:13 PM
