8
RADIO
wood in place.
C.
Secure the mini servo in place as shown. Install the EZ connector
on the servo horn. Insert the pushrod first then place the horn on the
servo. Make sure the servos are in neutral position then screw the
horn.
D.
Install the receiver, ESC, battery back as shown. Please refer to the
manufacturer's instruction manual for correct connection. Poke a hole
in the bottom of the cabin and run the antenna out and down the bot-
tom of the fuselage and attach to the tail using whatever method you
prefer.
E. Install the ESC switch
VIII. Balancing
E.
Balance the plane. With the wing on the airplane, use your two
index fingers to suspend the model in the air. Locate your fingers 1
1/4”back from the leading edge of the wing, about 4”out from the fuse-
lage. At this point, a right angle is formed where the leading edge and
the center balsa sheeting ends. You can feel this point with your finger
tips.
The plane should hang level or slightly nose down at this point. If
the tail drops, you need to redistribute or even add weight to the nose
until the plane balances.
IX. Control Throws
Make sure that all control surfaces move in the proper direction.
Set the control surface throws as indicated for the initial flights.
These may be altered later for personal preference.
Rudder
Elevator
3/4”
neutral
3/4”
1/2”
neutral
1/2”
