1 1
ASSEMBLY / WING
46. Locate the wing center cover then trim it along
the molded line as shown.
47. Glue the wing center cover in place with epoxy.
48. Epoxy the wing strut mounts in place note the
orientation of the ring.
49. Drill 2mm mounting holes on the molded dots.
Secure the main wing with two 3x30mm (front
wing bolt) and two 3x25mm (rear wing bolt)
wood screws.
50. Assemble the wing strut joiner as shown, you will
need to thread the threaded rod to the wing strut
joiner first then thread the clevis. A needle nose
pliers will help thread the rod. Epoxy the two
plastic tubes to the joiner; one is long and the
other is short.
51. Epoxy the strut hook in place as shown.
52. Wing strut will hook on the wing later. Use the
same way and assemble the other wing strut
53. Hook on the wing struts on two wing halves.
54. Snap on the clevis on the wing strut mount,
adjust the clevis if necessary.
Leading Edge
Trailing Edge
