THUNDER TIGER Jackal 6544-F, Инструкция по эксплуатации и каталог запасных частей

Страница: 7 / 30

BINDING PROCESS
安 全 校頻配對
(
鎖碼
)
6
6
我們的產品在出廠前已經過配對，您無需做配對動作便可使用。但如果您要將接收機跟另外
的發射機進行配對使用，或者您要更換新的接收機或者發射機，請您按如下的步聚進行：
注：我們的接收發射系統，不跟其它品牌相容！
a.
將
2.4G
發射機裝好電池，並關閉發射機。
b.
將配對線插入接收機的
BIND/CH3
通道介面（如圖
1
）。
c.
將接收機電池插入接收機的
VCC
通道介面，此時可看到接收機的
LED
在閃爍，此表示接收機進入配對狀態。
d.
將發射機上的配對鍵
(BIND)
按住，然後打開發射機電源開關。 （注：不要鬆開按鍵）。
e.
觀察接收機上的
LED
，如果發現
LED
不再閃爍表示配對成功。（注：此過程大約時間為
5S
左右）。
f.
鬆開發射機上的配對按鍵，拔掉接收機上的配對線。
g.
將伺服器裝上並通電測試。
h.
如果測試
NG
，則重複以上動作。
i.
如果測試
OK
，則將電源接頭插入
VCC
，配對完成。
Our products are well matched in the factory, you do not need to match by yourself. But if your
are going to match the receiver with other transmitter, or you need to change a new receiver
or transmitter, please follow the following steps;
a. Install the battery to 2.4G transmitter and shut it down.
b. Insert the matching lines to the channel BIND/CH3 port of the receiver. (Figure.1)
。
c. Connect the receiver battery to VCC port of the receiver, on the same time the two LED are flashing shing
and this means the receiver are going to the matching status.
d. Press and hold the button on the transmitter, and then switch on the power supply.
e. Observe the LED on the receiver, if find that the LED is not flash anymore and that means successful
Matched. (This process about 5s)
f. Release the match button on the transmitter, take out the match line.
g. Install the server and then test.
h. If the tests fail, please repeat the action above.
i. If the tests success, then insert the power supply port into VCC, match complete.
Bind Key
對碼按鈕
Battery
電池
Match line
對碼線
LED
Receiver
接收
Figure 1
圖 1