Canopy Installation
27. Trim the Canopy alone with the molded line. Cut a
hole at front top canopy so air could go in to cool
motor and battery when in the air.
28.Position the canopy in place. Drill three 1/16" (
1.5mm) holes then secure the canopy with
furnished 2 x 5mm Black Wood Screws.
Control Throws
These control throws are merely a starting point for
your radio setup and can be tailored to fit your flying
style.
Balance
29.Balancing your model is very important and must
not be overlooked. The center of gravity (CG) is
2-3/8" behind the leading edge of the wing near
the wing root. You can adjust the battery pack
forward or backward to reach the right CG.
2 3/8" (
60mm
CANOPY / CONTROL THROWS & BALANCING
2-3/8" (6cm)
Elevator-Low Rate
Aileron-Low Rate
Aileron-High Rate
Elevator-High Rate
3/8" (9mm)
3/8" (9mm)
1/4" (6mm)
1/4" (6mm)
1/2" (12mm)
1/2" (12mm)
1/4" (6mm)
1/4" (6mm)
