❐
17. Fit the main wing on fuselage, drill
1/16"(1.5mm ) wing mounting holes. Be careful
to drill the hole through the wing and
mounting block on fuselage. The mounting
holes should be centered near two ends of
mounting block.
2mm
❐
18. Trail Fit the bottom section. Make marks on
the bottom section.
❐
19. Place the bottom section then drill
5/64"(2mm) holes. Drill the bottom section
and make a drill mark on bottom section
mount. Remove the bottom section then drill
10
T
TA
AIIL
L FFE
EA
AT
TH
HE
ER
RS
S
the hole on bottom section mount as shown.
This is to prevent you from breaking the
mount when drilling.
2mm
❐
20. Secure the bottom section with the furnished
3x 15 mm wood screw.
3x 15 mm
❐
21.Remove the covering on the fuselage where
horizon tail goes. Insert the tail in place then
draw lines along fuselage on the tail at four
sides.
