9
prevent reverse polarity connection, and each balance connector adapter board is equipped with
balance connectors compatible with all 2S 7.4V to 14S 51.8V LiPo/LiIon/LiFe batteries equipped with
Thunder Power and JST-XH balance connectors. And in the event that you must connect batteries
that are not equipped with TP or JST-XH balance connectors, there are additional balance connector
adapter leads (i.e.
– TP to JST-EH, etc.) available from many sources.
After connecting the balance connector adapter board to the charger/balancer you can connect the
balance connector from the battery to the appropriate mating connector, ensuring proper keying of the
connectors and polarity on the board accordingly. And please note that unless you are using the
correct adapters/connections to charge multiple batteries in series and/or parallel (contact Thunder
Power RC directly for more information on series/parallel charging if needed) you must NOT connect
more than one battery to the balance connector adapter board. If you connect multiple batteries
incorrectly or connect one battery with incorrect polarity it is possible to damage the traces and/or the
pins/connectors on the balance connector adapter board. Such damage is not covered under
warranty.
OPERATING INFO
Button Functions
+/
– buttons
The +/
– buttons allow you to scroll up/down through menus before and during charging/discharging.
These buttons also allow you to change values/settings for options after they have been selected
(typically when flashing after pressing the ENTER button).
MODE button
The MODE button functions only before and not during charging/discharging. Pressing the MODE
button will allow you to scroll between the three available modes:
Charge/Discharge/Cycle/Storage Modes
Setting Data Mode
Data View Mode
ENTER button
