Thumpstar CHEETAH 150, Руководство владельца/оператора

Страница: 18 / 26

Periodic Maintenance and Adjustment
32 33
Periodic Maintenance and Adjustment
SERVICE AIR FILTER
Service air filter every 20 hours of use
1. Remove cleaner cover by removing the Phillips
head screws
2. Clean any excess dirt, oil or dust from the air
cleaner box with a mild detergent and water solution
3. Thoroughly dry the air box.
4. Replace the air cleaner element.
5. Carefully align the gasket between the air box
halves during re-assembly.
SERVICE SHIFTER ADJUSTMENT
Your unit might require an occasional adjustment
in the shifter cables due to physical stretch found
during normal operation of the vehicle. To make shift
adjustments, follow the below instructions.
1. Push the shifter lever to forward or “D”
position.
2. Check the shifter control disc found just
behind the oil level dipstick to ensure that it
has rotated forward all the way. Look for any
slack in control cable 1.
3. Loosen adjustment nuts #1 and #2, pulling
the housing to draw the cable tight until the
cable is properly tensioned.
4. Shift the lever to the “R” position and check
the control disc to ensure that it has rotated
full towards the rear of the vehicle.
5. Loosen adjustment nut #3 and #4, pulling the
cable housing to draw #2 control cable right.
6. Realign nut #2 and #4 when the cable is
properly tensioned.
FRONT WHEEL REPLACEMENT
Do not disassemble the castle nuts when you
replace the front wheels.
It is only necessary to remove the four lug nuts to
remove the wheel. Tighten the nuts after replacing
the wheels.
REAR WHEEL REPLACEMENT
Do not disassemble the castle nuts when you
replace the rear wheels and hub assembly.
Remove the cotter pin and then 24mm nut.
Then slide off wheel and hub assembly. It is only
necessary to remove the four lug nuts to remove
the wheels by itself.
FRONT WHEEL ALIGNMENT
The front wheels should be set with a “toe-in”
from 1/4” to 3/8”. At the center-line of the tires,
measure the Distance A and the Distance B. For
proper toe adjustment, Dimension A should be
1/4” – 3/8” greater than Dimension B.
1. Loosen the lock nuts on both sides of Front
Tie Rods.
Ensure the steering wheel is centered, and
adjust Dimension B by equally rotating the
tie rods in or out with a 12mmwrench.
2. After adjusting to the desired length,
tighten the lock nuts against the rod end.
3. Recheck the dimensions for proper
alignment.
1. Air filter cleaner cover
2. Air filter element
3. Air filter right Cover