Thumpstar CHEETAH 150, Руководство владельца/оператора

Страница: 12 / 26

Pre-Operating Checks
20 21
Operation
SEAT BELTS
Make sure that both seat belts are not frayed or damaged.
The seat belt must move smoothly when pulled out and retract on its own when
released. The latch plate should click securely into the buckle and release when
the release button is pushed firmly. Wash off any dirt or mud which could affect
operation. Have a dealer repair as necessary for proper operations.
STEERING
Pack on level ground. Turn the steering wheel right and left. Check for excessive
free play, abnormal noise, or a rough feeling. Have a dealer repair as necessary
for proper operation.
FITTINGS AND FASTENERS
Always check the tightness of chassis fittings and fasteners before a ride. Take a
vehicle to a dealer or refer to the service manual for correct tightening torque.
LIGHTS
Check the headlights and tail/brake lights to make sure they are in working
condition. Repair as necessary for proper operation.
SWITCHES
Check the operation of all switches. Have a dealer repair as necessary for proper
operation.
! WARNING
POTENTIAL HAZARD:
Operating this vehicle with improper tire, or with improper or uneven tire
pressure.
WHAT CAN HAPPEN:
Use of improper tires on this vehicle, or operation of this vehicle with improper
or uneven tire pressure, may cause loss of control, increasing your risk of
accident.
HOW TO AVOID THE HAZARD:
1. Use Proper Tires:
Front Tire: 22 x 7 - 10 Rear Tire: 22 x 10 - 10
2. The tires should be set to the recommended pressure.
Front: 15 PSI Rear: 15 PSI
! WARNING
POTENTIAL HAZARD:
Operating vehicle without being familiar with all controls
WHAT CAN HAPPEN:
Loss of control, which could cause an accident or injury.
Fuel expands when it heats up. If the fuel tank is overfilled, fuel could spill put
due to heat from the engine or the sun.
HOW TO AVOID THE HAZARD:
Read the Owner’s manual carefully. If there is a control or function you do not
understand, ask your dealer.
START A COLD ENGINE
1. Apply the brake.
2. Shift the drive select lever into the neutral position.
NOTE:
When the drive select lever is in the neutral position.
The engine can be started in any gear if the brake is applied. However, it is
recommended toshift into neutral before starting the engine.
3. With your foot off the accelerator pedal, start the engine by turning the key to
“START” position.
NOTE:
If the engine fails to start, release the key, and then try starting again. Wait a few
seconds before the next attempt. Each cranking could be as short as possible to
preserve battery. Do not crank the engine more than 5 seconds on each attempt.
4. See the “Engine Brake In” section prior to operating the engine for the first
time.