Thrax Audio Spartacus 300, Руководство по эксплуатации

Страница: 7 / 9

7
BACK PANEL
Input
A XLR jack is provided for balanced connection to a pre-amplifier.
NOTE
: Do not remove and connect input cables or speaker cables while the amplifier is
running , you risk damaging your loudspeakers or amplifier. Do not operate the amplifier
without a loudspeaker.
Speaker output
The speaker cables connect to the Speaker Connectors. Either banana jacks, bare wires
or spade plugs can be used. If bare wire is used, be careful that no stray strands get loose
and cause a short-circuit. The “Common” or “Ground” lead connects to the black jack.
The “Hot” lead goes to the red jacks. Bare wires and spade plugs must be tighten ed by
rotating the ratchet screw clockwise.
A/C Fuses
There are fuses located in the IEC power connector on the back panel. For 220 volt
operation 6.3 amperes "slow blow" fuses are used. For 110 volt operation the fuses should
be 10.0 amperes. If power does not come on, contact your authorized service
representative or consult the factory for more information.
300
INPUT
OUTPUT
TRIGGER
IN
Speaker Output
(Binding Posts)
XLR Input
A/C Fuses